Command access MLRK1-MRK Insert Instructions page 6

6.
Slide Push pad cover off just enough to reveal back (4) screws on
push pad.
8.
Remove pin from activating bracket then remove the (2) spacers on each side & discard. Next, re-insert pin into activating bracket.
9.
Place back activating bracket back into the push pad & line up with
existing screw holes.
1
11.
Flip over push pad exposing activating brackets.
U S c u s t o m e r s u p p o r t 1 - 8 8 8 - 6 2 2 - 2 3 7 7 | w w w . c o m m a n d a c c e s s . c o m | C A c u s t o m e r s u p p o r t 1 - 8 5 5 - 8 2 3 - 3 0 0 2
SCREWS
2
ACTIVATING BRACKET
7.
Remove (2) screws on the left to remove back activating bracket.
10.
Re-install (2) screws on the left to secure back activating bracket
to push pad.
12.
Pull back activating bracket over on to spring and hold in place.
6
1 2
1 2