E-Mail Data; Protocols - Johnson Controls FRICK QUANTUM LX AcuAir Communications Manual

acters or less in length, use no spaces and use only
upper and lower case letters. It is similar in concept
to the function of the Panel ID, and basically allows
the network router to interpret the actual IP address
of a particular unit as this host name. When using a
web browser within the system network, this name
can be entered as the web location that you wish
to visit (instead of having to type in the IP address).
After modifying a Host Name, you will be required
to cycle power. The network router could take up to
fifteen minutes to recognize the change.
Work Group – All of the Quantum™ LX units within
a network may be grouped into different categories.
These categories could be unit locations, or perhaps
categorized by unit function. For instance, if you
wanted to group the units by function, and had 10
units, and three of them were Air Handlers (located
on the roof), then Evap1 could be the name of a work
group. So name each unit by these functional Work
Group names. The Work Group name must be fifteen
characters or less in length, and can use numerals
and upper and lower case letters. When using the
network neighborhood feature of Windows® Explor-
er, by looking at your Network Neighborhood, you
would see the name of the Work Group, and within
that work group you would see the individual Host
Names of each unit within that work group. After
modifying a Work Group name, you will be required
to cycle power. The network router could take up to
fifteen minutes to recognize the change.
Server String – This is a comment area that can be
used in conjunction with the Host Name. For exam-
ple, if the Host Name is Booster1, you could set the
Server String to print something like DockBooster, or
some other additional information about the unit. The
Server String has no control function; it is strictly an
informational area.

E-MAIL DATA

The purpose of the E-Mail data feature is to allow the
controller to send a Warning or Shutdown message
to defined listing of recipients.
Email Notification On Warning Or Shutdown – For the
E-mail notification feature to work, it must be en-
abled (it is disabled as a default). The following drop-
down menu is provided:
• Disabled
• Enabled
QUANTUM™ LX AcuAir™ CONTROL PANEL
COMMUNICATIONS SETUP
Local Email Address - Use this setpoint box to enter
a valid E-mail address that has been assigned to the
internet account.
Alias Name For Local Email Address – Enter here a
custom name to identify more clearly the local Email
address. When a message is sent to all recipients,
this is the name that will appear in the Email FROM
column.
Subject - Enter a custom subject that you would like
to appear when a message failure is sent. When a
message is sent to all recipients, this is the wording
that will appear in the Email SUBJECT column.
SMTP Server Name OR IP Address - SMTP stands
for Simple Mail Transfer Protocol.
handle outgoing email, and accept email from oth-
er domains. When you set up an email client, you
must specify an outgoing server (sometimes called
an SMTP server). Often, this server is designated in
the form of smtp.domain.com. But this can vary, so
be sure to check with your email service provider or
LAN administrator to find out their outgoing server.
SMTP Server Port Number - This value is in almost
all cases going to be 25. This should be set by the
network or LAN administrator.
Comma-Delimited List Of Email Recipients - This is
simply the list of the Email addresses that you would
like to have any messages sent to. Separate each e-
mail address with a comma.

PROTOCOLS

The purpose of this section is to enable or disable the
Modbus TCP and Ethernet/IP parameters.
Modbus TCP:
• Disabled
• Enabled
Ethernet/IP:
• Disabled
• Enabled
090.510-CS (DEC 2012)
Page 11
SMTP servers