Set-Up For Use - Philips SBCRU631/00 User Manual

XP SBC RU 631/00 2002

SET-UP FOR USE

Carefully read the complete procedure before starting!
Your equipment is a Philips brand:
VCR
TV SAT
Press a few keys to check correct response.
Your equipment is of another brand, or your
equipment is a Philips brand, but not all keys
respond correctly:
VCR
TV SAT
1 3
-
1 9
That's it! Press a few keys to check correct response. If
response is not correct, repeat procedure beginning at step 1.
- If the LED displays one long flash, the code was not
- If no key is pressed within 30 seconds, you have to start
Carefully read the complete procedure before starting!
You do not know the brand of your
equipment/you can not find the right code in
the code list » auto search:
VCR
TV SAT
1 3
4
15-10-2001 12:35
Instructions for use
A d v i c e
1
Press the mode selector key for the device you want to
operate.
2
Press the power key to test.
– The green indicator LED under each device (TV, VCR or
SAT) lights up to confirm the mode you're in.
C h e c k
1
Press the mode selector key to select the device (TV, VCR
or SAT) you want to operate.
2
Look up the brand name of the device you want to
operate in the code list (centre of this manual).
Make sure you choose the correct code list for your device!
3
Make sure the device is switched on.
4
Press and hold keys 1 and 3 simultaneously - for about
three seconds- until the green LED lights up. (Release the
keys: the green LED should stay on)
5
Enter your 4-digit code using the number keys, within
30 seconds.
– The green LED flashes twice.
C h e c k
N o t e
recognised. Please go back to step 1 and repeat the
procedure, using the next 4-digit code in the list.
again at step 1.
A d v i c e
1
Press the mode selector key to select the device (TV, VCR
or SAT) you want to operate.
2
Make sure the device is switched on (if the device is a
VCR, please insert a tape and start playback).
3
Press and hold keys 1 and 3 simultaneously -for about
three seconds- until the green LED lights up.
(Release the keys: the green LED should stay on)
Pagina 4