Advertisement
3
Installing the Adapter Kit
Units Without a Groomer Only
Parts needed for this procedure:
1
Adapter kit—Part No. 132-0723 (sold separately)
Procedure
For a cutting unit without a groomer, the adapter kit
provides the necessary mounting points for installing
the brush kit.
1.
Remove the screws securing the weight and
remove the weight
1. Weight
2. Screw
2.
Remove the cap from the center of the weight
(Figure
7).
3.
Restrain the reel; refer to
for Removing Threaded Inserts (page
4.
Remove the bearing screw
Note:
If the bearing screw is on the right side
of the cutting unit, it has standard right-hand
threads. If it is on the left side of the cutting unit,
it has left-hand threads.
(Figure
7).
Figure 7
3. Cap
Restraining the Reel
12).
(Figure
8).
1. Bearing screw
5.
Secure the driveshaft to the driveshaft adapter
(Figure
9) and torque it to 149 to 162 N∙m (110
to 120 ft-lb).
Note:
The kit includes 2 driveshaft adapters—1
for a right drive configuration (silver, right-hand
threads) and 1 for a left drive configuration
(black, left-hand threads).
g032588
Left Drive Configuration Shown
1. Driveshaft
2. Driveshaft adapter (black,
left-hand threads)
6.
Restrain the reel; refer to
for Installing Threaded Inserts (page
7.
Torque the drive shaft adapter assembly to the
reel and torque to 135 to 150 N∙m (100 to 110
ft-lb).
Note:
For a cutting unit requiring the left drive
configuration, install the shim washer under the
driveshaft adapter
8.
Install the weight with the screws that you
removed in step
5
Figure 8
Figure 9
3. Shim washer
Restraining the Reel
13).
(Figure
9).
1 (Figure
10).
g032589
g032597
Advertisement
