Figure 22
Right Drive Configuration
1. Drive pulley
2. Belt
Ensure that any cutting units that use a left drive
configuration are set up correctly; refer to
Figure 23
Left Drive Configuration
1. Drive pulley
2. Belt
g032465
3. Idler
4. Driven pulley
Figure
23.
g032697
3. Idler
4. Driven pulley
10
Installing the Cover
Parts needed for this procedure:
1
Cover
3
Hex-socket screw (1/4 x 3/8 inch)
Procedure
Use the 3 hex-socket screws (1/4 x 3/8 inch) to secure
the cover to the drive housing
Note:
Position the cover so that the notch is at the
bottom.
1. Cover
2. Notch
11
(Figure
24).
Figure 24
3. Hex-socket screw (1/4 x
3/8 inch)
g033565