Advertisement
Restraining the Reel for Installing
Threaded Inserts
1.
Insert a long-handled pry bar (recommended 3/8
x 12 inches with screwdriver handle) through the
front of the cutting reel, closest to the side of the
cutting unit that you are torquing
2.
Place the pry bar against the weld side of the
reel support plate
Note:
Insert the pry bar between the top of the
reel shaft and the backs of the reel blades so
that the reel does not move.
Important:
Do not contact the cutting edge
of any blades with the pry bar; this may
damage the cutting edge or cause a high
blade.
Important:
The insert on the left side of
the cutting unit has left-hand threads. The
insert on the right side of the cutting unit has
right-hand threads.
Figure 26
1. Threaded insert for
installation
2. Reel shaft
3.
Rest the handle of the pry bar against the roller.
4.
Following the installation instructions for the
insert, complete installing the threaded insert,
ensuring that the pry bar remains in place.
5.
Remove the pry bar from the cutting unit.
(Figure
(Figure
26).
3. Weld side of the support
plate
4. Pry bar
26).
g280287
13
Advertisement
