Counter-rotating groomer drive system dpa cutting units for greensmaster flex 1800/2100, eflex 1800/2100, andtriflex 3300/3400 series traction unit (16 pages)
18in and 21in, 11-blade and 14-blade edgeseries cutting unit (20 pages)
Summary of Contents for Toro 04135
Page 1
If you install this kit to a Model 04860 or 04861 traction unit, ensure that the part number for the kit wire harness is 122-2178. If you have an older wire harness (Part Number 122-1418), replace it with the new wire harness (Part Number 122-2178); refer to your authorized Toro distributor for the new wire harness. Preparing the Machine No Parts Required Procedure Park the machine on a level surface.
Installing the Lights Parts needed for this procedure: LED light Light mount Mount cap Bolt (3/8 inch) Bolt (5/16 inch) Nut (3/8 inch) Nut (5/16 inch) Procedure Use 2 bolts (3/8 inch), 2 bolts (5/16 inch), 2 nuts (3/8 inch), and 2 nuts (5/16 inch) to secure the light mounts to the machine frame (Figure Install the mount caps onto the mounts...
Page 3
• Connect the WHM wire-harness end labeled J01 to the white end of the engine wire harness. • Connect the WHM wire-harness end labeled Installing the Wire Harness J02 to the black end of the light-kit wire harness labeled J02. •...
Operation Operating the Lights Installing the Switch • Turn on the lights: Press the top of the switch (Figure • Turn off the lights: Press the bottom of the switch Parts needed for this procedure: (Figure Switch Procedure Remove the plug from the handle (Figure Connect the switch with the 8-socket connector of the wire harness...
Page 7
The method of transmission shall be electronic transmittal. This machinery shall not be put into service until incorporated into approved Toro models as indicated on the associated Declaration of Conformity and in accordance with all instructions, whereby it can be declared in conformity with all relevant Directives.