Advertisement
Figure 15
1. Left bracket
2. Bearing cover
2.
Insert the end of the brush shaft without the
splines into the shaft collar in the bracket
assembly (non-drive side) as shown in
16.
Figure 16
1. Bracket assembly (non-drive side)
3.
Install the small retaining ring and a flocked seal
onto the splined end of the brush shaft
17).
g032560
3. Nut
4. Bolt
Figure
g032462
(Figure
1. Small retaining ring
4.
Insert the splined end of the brush shaft through
the bearing in the drive-side bracket as shown
in
Figure
17.
8
Figure 17
2. Flocked seal
g032463
Advertisement
