Table of Contents
Advertisement
4. Install the O-ring on the reel motor
1. O-ring
5. Install the reel motor, and grease the side plate until
excess grease comes out of the grease vent
5
Installing the Fixed Plate Kit
(Optional)
Parts needed for this procedure:
1
Fixed plate kit (not included)
Procedure
1. Remove the nuts and washers securing the lift links to
the cutting-unit side plate and carrier frame
1. Nuts
2. Using the number 2 holes, insert a fixed plate onto the
bolts and secure it with the nuts removed.
Note: The number 1 holes are to be positioned toward
the front. Do not reuse the washers.
(Figure
7).
Figure 7
(Figure
(Figure
Figure 8
2. Washers
Note: The number 1 hole is a less aggressive setting
and the number 3 hole is a more aggressive setting.
g191072
6).
1. Nuts
3. Loosen the locknuts securing the height-of-cut brackets
to the cutting-unit side plates
9).
1. Height-of-cut bracket
2. Locknut
4. Remove the height-of-cut brackets and the roller from
the cutting unit.
5. Repeat the procedure on the remaining cutting units.
g011962
6
Figure 9
2. Fixed plate
(Figure
10).
Figure 10
3. Adjusting screw
g011963
g003326
Advertisement
Table of Contents
