Installing The Kit - Toro ProStripe 560 Installation Instructions Manual

Installing the Kit

1. If the grass bag is on the machine, remove the it.
2. Remove the chain cover from the machine by removing the 2 chain-cover bolts
Note:
Retain the chain cover and 2 chain-cover bolts for later installation.
3. Remove and retain the existing circlip, thrust washer, sprocket, and chain from the gearbox post
1. Gearbox post
2. Chain
3. Sprocket
4. Thrust washer
4. Remove the roller and all corresponding parts from the machine.
Note:
Retain all corresponding parts except the shaft, washer (M6 x 18), and bolt (M6 x 25).
5. Fill the cam drive cavity with grease that has superior water resistance such as Fuchs Renolit CZ2
grease or similar.
Important:
Do not use standard grease as this may allow moisture to reduce lubricant efficiency.
6. Replace the shaft, washer (M6 x 18), and bolt (M6 x 25) as shown in
Note:
Apply thread-locking compound on the bolt and torque it to 11 N·m (8 ft-lb).
Figure 1
5. Circlip
6. Chain cover
7. Chain-cover bolts (2)
2
(Figure 1).
Figure 2.
(Figure 1).
g349697