Toro 04650 Installation Instructions Manual page 4

Figure 4
1. O-rings
4. Align the bearing and the flocked seal that you
removed in step 2
and rotate them to the original position
5).
Figure 5
Left Drive Configuration
1. Left bracket
2. Bearing
3. Flocked seal
4. Assembled parts
5. Hex-socket screw
6. Right bracket
5. Align the assembled shaft collar, bearing, and
flocked seals in the slots in the right bracket, and
rotate the parts to the original position
6. Prepare the idler assembly as follows:
A. Remove the hex-socket screw securing the
bushing and the spring to the idler assembly
(Figure 6).
in the slots in the left bracket,
(Figure
7. Bearing cover
8. Locknut
9. O-ring
10. Flocked seal
11. Bearing
12. Shaft collar
(Figure
g032677
B. Remove the spring, flip it over, and install it
as shown in
g032562
C. Secure the spring and the bushing with the
screw that you removed in step A.
5).
4
Figure 6
Left Drive Configuration
Figure 6.
g032676