Table of Contents
Advertisement
Charge Battery
Connect Contra Angle
Contra Angle
Line up the match marks and push the contra angle onto the motor handpiece until there is an audible click.
* The contra angle must be lubricated with LS Oil before using for the first time. Refer to "Lubricate the Contra Angle
with LS Oil" .
• Make sure the connection components for both the motor handpiece and the contra angle are not damaged. An improper connection could cause the motor
to reverse unexpectedly and result in injuring the patient.
• Push the contra angle all the way onto the motor handpiece and then give it a light tug to make sure it is securely attached.
9
The number of bars shows how much battery power is left.
Recharge the battery when there is only one bar left.
If the battery runs almost completely out, the EndoSync will automatically turn itself OFF after
about 10 seconds. Recharge the battery as soon as possible.
If the battery power is very low and a large load is applied to the file, the motor may stop or
the unit may turn itself OFF .
This is for safety; there may not be enough power to run the motor with sufficient stability.
Recharge the battery if the display shown to the left appears frequently.
Line up the marks.
Motor Handpiece
Approx. 290°
The rotation range of the contra angle is about 290°.
Set it so that it reaches the treatment area and the dis-
play is easy to see.
Do not force the contra angle to rotate beyond its limit.
Operation 2016-03-07
Advertisement
Table of Contents
