Adjusting The Running Belt - Sunny Health & Fitness SF-T7951 User Manual

General cleaning will help prolong the life and improve the performance of your treadmill. Keep the
unit clean and maintained by dusting the component on a regular basis. Cleaning the two exposed
sides of the Running Belt (No. 68) will prevent dust from accumulating underneath. Keep your
running shoes clean so that dirt from the shoes does not wear the Running Belt (No. 68) and
Running Board (No. 15). Clean the surface of the Running Belt (No. 68) by using a clean damp
cloth. Keep liquids away from electrical parts and Running Belt (No. 68).

ADJUSTING THE RUNNING BELT

Place the treadmill on level ground and set it at 3.5-5 MPH to check and see if the Running Belt
(No. 68) drifts from the center. Adjust the Running Belt (No. 68) according to instructions below
with Allen Wrench (No. 12).
If the Running Belt (No. 68) drifts to the
right, remove the Safety Key (No. 13), turn
the adjusting bolt on the right side 1/4 turn
clockwise, then start running until the
Running Belt (No. 68) is centered. Refer
to image A.
If the Running Belt (No. 68) drifts to the
left, remove the Safety Key (No. 13), turn
the adjusting bolt on the left side 1/4 turn
clockwise, then start running until the
Running Belt (No. 68) is centered. Refer
to image B.
Over time, the Running Belt (No. 68) will
loosen. To tighten the Running Belt (No.
68), remove the Safety Key (No. 13), turn
both the left & right side adjusting bolts 1/4
turn clockwise, then re-start running the
belt. Check the tension of the Running
Belt (No. 68). Continue this process until
the Running Belt (No. 68) is at the correct
tension. Make sure to adjust both sides
equally to ensure even alignment. Refer to
image C.
MAINTENANCE GUIDE
9