Integrating The Decoder Into The Video System; Configuring The Decoder With Video Client - Bosch VIDEOJET decoder 7000 Installation Manual

VIDEOJET decoder 7000
Subnet mask
Enter an appropriate subnet mask for the IP address.
Gateway address
If required, enter an appropriate gateway address.
Notice!
A new IP address, or a new subnet mask or gateway address, does not become valid until the
decoder is restarted.
After entering all required addresses, it is necessary to restart the decoder:
1.
2.
3.
6.2

Integrating the decoder into the video system

In order to integrate the decoder into a video management system which only operates the
decoder, relevant settings can be made with the Configuration Manager.
1.
2.
3.
4.
5.
6.
7.
8.
6.3

Configuring the decoder with Video Client

For a detailed description to integrate the software in the Video Client application, see the
Video Client documentation.
Monitor wall tab
You can only set up a monitor wall if you have added decoders to your system. The available
decoders are listed in the Decoders box. Decoders that belong to a site are only listed if the
site is connected.
Note that this tab is not available if you have used direct logon.
1.
2.
3.
Bosch Securtity Systems B.V.
In the toolbar, click
Confirm the restart.
After restart, the software is available for use under the new addresses.
Start the decoder.
Start Configuration Manager on a separate PC.
Configuration Manager automatically scans the network for compatible devices. The
software detects the decoder and lists it in the main tab Devices.
In the list of identified devices, right-click the entry for the decoder.
The pop-up menu appears.
Select the Add to System... command from the pop-up menu.
The Add Device to System dialog box is displayed.
You can select an existing group into which you want to integrate the decoder.
To create a new group, enter a name for the group.
You can also continue without selecting or creating a group.
Click OK.
Switch to the main tab My Devices.
The decoder appears in the list of devices assigned to the system.
Drag a decoder from the Decoders box to a free position on the monitor wall grid.
Alternatively, select a decoder and a free position and click
Drag a decoder in the grid to a new position to rearrange the grid.
To free a position, select it and click
listed in the Decoders box.
.
. The decoder is removed from the grid and
Installation manual
Configuration | en 17
.
2019.10 | v01 | F.01U.345.382