Brother HL-2290 Service Manual page 48

Error message
Initial display
Size Error DX Press Go for 2
seconds. Specify
the correct paper
and load the same
size paper as the
Printer driver
setting.
Specify the correct
paper.
Size mismatch Load #S paper in #T
and press Go.
Toner Ended Open the Front
Cover, replace
Toner Cartridge.
Toner Low -
Wrong Toner Open the Front
Cover, then install
Toner Cartridge
2-sided Close the Back
Disabled Cover of the
machine.
Scroll
For 2-sided printing, paper size
setting of the printer driver that
was not supported by 2-sided
printing was selected.
The registration rear sensor
detected that the paper fed was
smaller or larger than the
specified size in duplex printing
mode.
The size of paper loaded in the
MP tray and the one specified
from the driver are not same
when paper is fed from the MP
tray.
The size of paper loaded in the
paper tray and the one specified
from the driver are not same
when paper is fed from the
paper tray.
Toner cartridge in models
without toner box has reached
the upper limit in the continuous
printing mode.
Dot counter of the toner
cartridge or develop roller
counter reaches the upper limit
soon.
The amount of toner supplied of
the toner box reaches the upper
limit soon.
Cartridge sensor detected that
the incompatible toner cartridge
was installed.
The back cover sensor detected
the open state when 2-sided
printing is started (before the
registration of printing in the
engine).
The back cover sensor detected
the open state during 2-sided
printing (after the registration of
printing in the engine).
2-26
Description
Error Refer
codes to:
9701 2-50
8A01 2-47
9001 2-48
9002 2-48
4E01 2-38
4B01 2-38
4B06 2-38
2200 2-37
8903 2-47
8904 2-47
Confidential