Brother HL-B2000D Quick Setup Manual

HL-B2000D
Quick Setup Guide
Unpack the machine and check the components
Watch our Video FAQs for
help with setting up your
Brother machine:
support.brother.com/videos.
1
Remove the packing materials and install the drum unit and toner cartridge assembly
2
Load paper in the paper tray
3
Connect the power cord and turn the machine on
Back
Drum Unit
Brother Installation Disc
Reference Guide
AC Power Cord
(only for certain models)
Adjust the paper
Front
Read the Product Safety Guide first, then read this Quick
Setup Guide for the correct installation procedure.
Not all models are available in all countries.
The latest manuals are available at the Brother Solutions
Center: support.brother.com/manuals.
Inbox Toner Cartridge
Quick Setup Guide
(only for certain models)
Product Safety Guide
1
2
1
Remove the orange part.
Do not exceed this mark.
guides.
Printer LED Indications
Toner
1
Low
Toner
Drum
Paper
Ready
1 The yellow LED will blink in a pattern of ON for 2 seconds and then OFF for 3 seconds.
2 The LED will blink ON and OFF at 0.5 second intervals.
NOTE:
• The components included in the box may differ depending on your country.
• Interface cables are not included. You must purchase the correct interface
cable if you require one.
USB cable
We recommend using a USB 2.0 cable (Type A/B) that is no more than
2 metres long.
• The illustrations in this Quick Setup Guide show the HL-B2000D.
• The Reference Guide is available on the provided Brother Installation Disc
in countries where it is not included in the box.
Push firmly.
Blinking:
Replace Drum End Replace
2
Drum !
1
Toner Soon Drum
D00TSN001-00
ASA
Version 0
ON: or OFF:
Paper Jam /
No Paper
2
Cover is Open