Brother HL-2290 Service Manual page 195

<Operating Procedure>
(1) Press the [▲] or [▼] in the initial state of maintenance mode to display "MAINTENANCE
10" on the LCD.
(2) Press the [OK]. "WSW00" is displayed on the LCD, indicating that the machine is ready
for worker switch number entry.
(3) Press the [▲] or [▼] to display the worker switch number for which you want to change
the setting on the LCD.
(4) Press the [OK]. The following message is displayed on the LCD, and selector No.1
flashes.
Selector No. 1
WSWXX = 0 0 0 0 0 0 0 0
(5) Pressing the [▲] enters "1", and pressing the [▼] enters "0". Press either to enter
desired number to Selector No.1. The next digit starts flashing.
(6) Keep entering numbers to Selector No.8 using the [▲] or [▼] as described in the
procedure (5).
(7) Press the [OK]. The new selector setting value is stored in the EEPROM, and the LCD
returns to the ready state for worker switch number entry ([WSW00]).
(8) When all switch setting is completed, press and hold the [Go] for five seconds to return
the machine to the initial state of maintenance mode.
Selector No. 8
5-11
Confidential