Brother HL-2290 Service Manual page 47

Error message
Initial display
Print Unable Turn the power off
E7 and then back on
again.
Print Unable Turn the power off
E9 and then back on
again.
Print Unable Turn the power off
ZC and then back on
again.
Replace Drum -
Replace Toner -
Open the Front
Cover, then install
Toner Cartridge
Open the Front
Cover, replace
Toner Cartridge.
Self- Turn the power off,
Diagnostic then on again.
Leave the machine
for 15 min.
Will Automatically
Restart within 15
minutes.
Size Error Specify the correct
paper size for Tray
1.
Scroll
Read error in the flash ROM
An error occurred while
initializing the NFC.
Detected that supply power is
unstable. (less than 100 times)
Number of the drum unit
rotations has reached the upper
limit.
Dot count or develop roller
counter of the toner cartridge in
models without toner box is
reaching the upper limit in the
continuous printing mode.
The amount of toner supplied of
the toner box has reached the
upper limit.
Dot count or develop roller
counter of the toner cartridge in
models without toner box has
reached the upper limit in the
toner stop mode.
Some fuser unit errors occurred
at power-ON or upon recovery
from sleep mode.
After the error was detected at
the fuser unit, power was turned
ON again and the error is being
checked. (If power is turned
OFF and ON after error code
6901 occurred, this code is
displayed for about 15 minutes.)
For printing by feeding paper
from the paper tray, the size of
paper specified from the driver
set the size which was not
supported by the paper tray.
2-25
Description
Error Refer
codes to:
E702 2-51
E900 2-51
6F00 2-44
4200 2-38
4D01 2-38
4C06 2-38
4C01 2-38
6901 2-43
6902 2-43
9702 2-50
Confidential