Table of Contents
Advertisement
HEAVY DUTY STAIR LIFT: SECTION 4
INSTALLATION
Figure 4-24
10. Connect the seat cable to the 8-pin connector
on the chassis. See Figure 4-25.
Figure 4-25
11. If the lift is equipped with the optional key
lock, ensure that the key switch on the armrest
control is in the locked position; the key should
be in the vertical position. See Figure 4-26.
Figure 4-26
12. Turn the red "ON/OFF" switch located on the
top of the chassis to the "ON" position. You
should hear a single beep and the LED indicator
light on the armrest control should cycle through
a test sequence, showing red, yellow and green
respectively. If any of the system controls or
safety sensors are engaged the LED indicator
light will turn to yellow.
13. If the LED indicator light is not green, check the
safety sensors. If the LED indicator light is still
SL600HD Heavy Duty Stair Lift:
14
31JAN2020 | P/N: 75403 REV C
Seat swivel sensor
Footrest lower sensor
Upper foot pan safety
sensor
Front foot pan safety
sensor
Uphill safety sensor
Downhill safety sensor
REMOTE CONTROL
PROGRAMMING
All call/send controls are factory programmed.
Re-programming is not normally necessary during
installation. In the event that the remove call/send
control needs to be re-programmed, it is essential to
program BOTH controls in one programming cycle.
Do so by completing the following.
1. Start with the red "ON/OFF" switch in the "Off"
2. Disconnect the 6-pin footrest and 8-pin chair
3. Press and hold the install switch (located on the
Installation & Service Manual
not green after testing sensors, turn the unit
off and re-check all wire plugs. Turn the unit on
again and re-check the LED indicator light cycle.
When the LED indicator light remains green, the
lift is ready to operate. See Figure 4-27.
Seat should be in the
locked position
Check by pushing in on
the safety pan on the
footrest
Check by pushing on
the safety pan on the
footrest
Check by pushing on
the safety pan on the
footrest
Ensure nothing is
blocking upward
passage
Ensure nothing is
blocking downward
passage
Figure 4-27
position.
wire harness from the chassis.
Hide quick links:
Advertisement
Table of Contents
