Remote Call/Send Controls - Harmar Mobility IL500 Sierra Inclined Platform Lift Installation & Service Manual

Remote Call/Send Controls

REMOTE CONTROL PROGRAMMING
If there are multiple lifts in the home, the infra-red remote controls can be programmed to
work with individual lifts.
1. Remove the battery door on each IR remote.
2. Move the dip switches to a different code. The two remotes must be set to the same code.
3. Replace the battery doors.
4. Use the unit control switch to move the lift so that it is not on a limit switch.
5. Turn the ON/OFF switch or main breaker to OFF.
6. Disconnect the two wire harnesses between the chassis and the platform mount.
7. Turn the ON/OFF switch or main breaker to ON. Fast beeping should occur indicating the
circuit board is in the IR Learning mode.
8. Aim the first IR remote at the chassis, press and release the UP or DOWN button. The fast
beeping should end with a single beep, indicating that the first remote is programmed.
9. Aim the second IR remote at the chassis, press and release the UP or Down button. Two
beeps should sound indicating the second remote is programmed.
10. Turn the ON/OFF switch or main breaker to OFF and reconnect the wire harnesses.
11. Turn the ON/OFF switch or main breaker to ON and test each remote in each direction.
14
| www.harmar.com | 800-833-0478
TEC0029 2016SEPT12 PN: 630-00001 REV C