Operation; Power Supply; Remote Control; Mid Level Parking - Harmar Mobility HELIX Owner's Manual

Curved stairlift
Hide thumbs Also See for HELIX:
Table of Contents

Advertisement

SECTION 3

OPERATION

1.
Fold down the armrests and seat before using
the lift.
2.
Tighten seat belt.
3.
Start moving the lift by using the rocker button
on the armrest, push the rocker button in
the direction you want to ride and maintain
pressure until the lift reaches its final position
and stops automatically.
4.
Use the seat swivel handle to turn the seat to
dismount after it has reached the final stop (top
position). It is now possible to fold up the foot
support, seat, and armrests to save space.
5.
Ensure that the key switch (optional) is "On".
When the lift is turned "On" a green light on the
chassis and a single audible beep will indicate
that the lift is ready for use.
NOTE: A seat swivel locking device on the seat prevents
the lift from being operated unless the seat is in its
operating position.

POWER SUPPLY

The stairlift should be kept fully charged at all times.
When the lift stops at an upper or lower landing it
will charge automatically. The charger should be left
plugged in at all times and the lift may be left on
charge. A green light indicates the supply is on.
NOTE: The unit will beep if it is not charging.

REMOTE CONTROL

The remote control allows the stairlift to move from
its parked position. Press the up or down button
for the desired direction. Keep the button pressed
until the lift reaches its final position and stops
automatically.
HELIX CURVED STAIRLIFT: SECTION 3
WARNING
!
Before using the remote, always check that no one
is in the process of getting on or off the lift. The
remote can move the unit when it is not in sight.
NOTE: When the stairlift stops in the parked position,
ensure that the charger light is lit. It indicates the lift has
stopped in the correct charging position.
WARNING
!
Always use the seat belt when using the lift.

MID LEVEL PARKING

When the unit comes in contact with the mid-level
charger, it will stop for about 3 - 5 seconds. If the
remote or toggle is released at that point, the lift
will charge at that location.
HELIX:
24SEP2021 | 610-00039-01 REV D
OPERATION
Owner's Manual
7

Advertisement

Table of Contents
loading

Table of Contents