Faq - Ranger RML-1500XL Installation And Operation Manual

Atv/motorcycle lift
Hide thumbs Also See for RML-1500XL:
Table of Contents

Advertisement

• Tie-Down Poles. Tall poles on the Ramp end of the Lift that give you options for securing the
Motorcycle or ATV on the Platform. You are not required to use them.
• Connecting Rods. Three long Rods that connect the Side Extensions and the Front Extension to
the Platform. Used in ATV Mode. Each Connecting Rod has a Lock Bolt on each end (to prevent
the Connecting Rod from slipping out) and a Cotter Pin for each Lock Bolt (to keep the Lock Bolt
from coming out).
Frequently Asked Questions
Question: How much weight can the RML-1500XL raise?
Answer: The RML-1500XL can raise ATVs or Motorcycles up to 1,500 pounds (680 kg).
Q: What if I want to raise an ATV or Motorcycle that is slightly over the weight capacity?
A: Do not do this! This is not an intended use of the product; you could damage the Lift and injure
bystanders. You must not raise any loads that are heavier than the rated capacity of the Lift.
Q: How far off the ground will the RML-1500XL raise my Vehicle?
A: It depends on which Safety Lock you engage on. The RML-1500XL has six Safety Lock positions,
so you can raise your vehicle anywhere from 24 in / 610 mm to 41 in / 1,041 mm off the
ground, whichever height is the right height for the work you are doing.
Q: Can the RML-1500XL be installed or used outside?
A: Yes. That being said, an outside environment is harder on the Lift. Our recommendation is to
use the Lift inside. If you have to use it outside, we recommend storing it inside, moving it
outside while you are using it, then moving it back inside when not in use. Keep the Lift clean
and dry as much as possible, especially the Air/Hydraulic Pump.
Q: Can I put the Air/Hydraulic Pump on either side of the Lift?
A: Yes. The Air/Hydraulic Pump can be located on either side, as far away as the Hose allows.
Q: What do Safety Locks do?
A: Safety Locks use gravity to hold the Platform up, once the Lift is engaged on a Safety Lock. Even
if the Lift loses power, the Platform stays where it is if you engaged on a Safety Lock. When you
raise a Vehicle, make sure to engage the Lift on a Safety Lock.
Q: Which end of the Lift is the "front"?
A: The end with the Clamp Assembly. The other end, the rear, has the Ramps.
Q: Anything else I should be aware of?
A: Be careful around the Lift. Be safe. Do not ride the vehicle onto it. Do not let people sit on a
vehicle while it is on the Lift. Pay attention and use common sense, and the Lift will be a
long-lasting, useful tool.
RML-1500XL ATV / Motorcycle Lift
8
P/N 5900183 — Rev. E — Feb. 2020

Advertisement

Table of Contents
loading

Table of Contents