Ranger RML-1500XL Installation And Operation Manual page 13

Once the Hydraulic Hose is connected, you can use the Raising Pedal to raise the Lift.
If you plan on using a pressurized Air Supply to raise the Lift and the Air Supply is nearby and
ready, you can connect the Pneumatic Hose to the Air/Hydraulic Pump and then use the Raising
Trigger to raise the Platform.
⚠
WARNING
7. Use the Raising Pedal or the Raising Trigger to raise the Platform to full height.
As the Platform rises, the Safety Lock Plate falls into each Safety Lock; you hear an audible clank
when this happens. This is normal operation; it also gives you a clear indication that the
Platform is rising normally and lets you know when a Safety Lock has been passed.
If you are raising the Platform using the Raising Pedal, the clank may be less loud or not audible
at all, as you are raising the Platform more slowly.
8. Put a Strap around the middle of the Platform, then use a Forklift or Shop Crane (or other
appropriate lifting device) to raise the Lift up and then away from the Shipping Box.
⚠
WARNING
9. Move the Shipping Box away from the area where you are setting up the Lift; it is a tripping
hazard.
10. Use the Lowering Pedal to lower the Lift until it engages on the top Safety Lock.
You should only leave the Lift either fully lowered or engaged on a Safety Lock.
RML-1500XL ATV / Motorcycle Lift
The Lift uses pneumatic (air) energy; if your organization has Lockout/Tagout
policies, make sure to implement them once the Lift is connected to a
pressurized Air Supply.
Only allow trained personnel to put the Strap in position or use the lifting device.
Be careful moving the Lift; it is heavy and awkward. Take your time and be safe.
If the Lift falls, it could damage the Lift or injure anyone nearby.
13
P/N 5900183 — Rev. E — Feb. 2020