Ranger RML-1500XL Installation And Operation Manual page 16

Refer to the drawing on the previous page during installation.
To install Lift components:
1. Put the Cover into place at the Ramp end of the Lift.
2. Take the Front Extension and slide it over the non-Ramp end of the Lift.
You can easily identify this end of the Lift because it has the drilled holes used later to install
the Clamp Assembly. These hole are shown in the drawing on the previous page.
Make sure to align the holes in the side of the Front Extension with the holes in the side of the
Platform.
3. Locate the three Connecting Rods.
4. Put the three Connecting Rods into place through the holes in the sides of the Platform and the
Front Extension.
5. Locate the two Side Extensions.
6. Put the two Side Extensions into place (one at a time), one on each side of the Platform.
Do not knock the Connecting Rods out when you put on the Side Extensions.
7. Locate the six Lock Bolts and Cotter Pins.
These should be located in the Parts Bag that came with the Lift.
8. Put the Lock Bolts through the holes in both ends of the Connecting Rods, then secure each
Lock Bolt in place with a Cotter Pin.
9. Locate the two ATV Ramps and the two Stability Rods.
10. Screw one Stability Rod onto the bottom of each ATV Ramp.
11. Put the ATV Ramps into place on the Ramp end of the Lift.
The two ATV Ramps are not the same, so make sure to orient them correctly.
Make sure to put the flanges under the ATV Ramps into the Placement Holes on the Base.
12. Test each ATV Ramp to make sure it is stable.
13. If desired, add the Motorcycle Ramp on top of the ATV Ramps.
RML-1500XL ATV / Motorcycle Lift
16
P/N 5900183 — Rev. E — Feb. 2020