Ranger RML-1500XL Installation And Operation Manual page 17

Installing the Clamp Assembly
The Clamp Assembly holds the front tire of the ATV or Motorcycle in place while it is on the Lift. It
includes three pieces, all of them yellow. The Tire Stop, which bolts onto the Platform, is also
yellow.
To install the Clamp Assembly and Tire Stop:
1. Locate the three pieces of the Clamp Assembly (Handle Assembly, Moveable Clamp Arm, and
Bolted Clamp Arm), the Tire Stop, and 14 Bolts, Flat Washers, Split-Lock Washers, and Nuts.
The Bolts, Washers, and Nuts should be located in the Parts Bag that came with the Lift.
2. Orient the Handle Assembly so that the four holes in the base are aligned over the four holes in
the Platform.
3. Use four of the Bolt, Washer, and Nut sets to secure the Handle Assembly to the Platform.
BendPak Ranger recommends orienting your Bolts, Washers, and Nuts as shown here.
4. Use four more Bolt, Washer, and Nut sets to secure the Handle Assembly to the Moveable
Clamp Arm.
5. Use six Bolt, Washer, and Nut sets to secure the Bolted Clamp Arm to the Platform.
6. Find the Tire Stop and use two Bolt, Washer, Nut sets to secure it to the end of the Platform.
RML-1500XL ATV / Motorcycle Lift
17
P/N 5900183 — Rev. E — Feb. 2020