Table of Contents
Advertisement
Using the Casters
The Lift has built-in Casters, making it easy to move the Lift to different locations.
To move the Lift using the Casters:
1. Find a 10 mm hex key (also called an Allen® key or wrench).
2. Locate the four Caster Adjustment Rods on the Base of the Lift.
The two Caster Adjustment Rods on the Ramp end of the Lift may be under the gray ATV Ramps
if you have installed them already.
3. Turn each of the four Caster Adjustment Rods clockwise to engage the Casters.
The Base rises slightly as the Casters engage.
4. When all four Casters are engaged, carefully roll the Lift to the desired location.
5. When the Lift is at the desired location, turn each of the four Caster Adjustment Rods
counterclockwise to lower the Base back down onto the ground.
Make sure the Lift cannot move on the Casters before raising a vehicle at the new location.
RML-1500XL ATV / Motorcycle Lift
21
P/N 5900183 — Rev. E — Feb. 2020
Advertisement
Table of Contents
