Table of Contents
Advertisement
Raising a Vehicle
The Platform is raised using the Air/Hydraulic Pump.
To raise a vehicle:
1. Make sure you are wearing OSHA-approved (publication 3151) Personal Protective Equipment:
leather gloves, steel-toed work boots, back belts, hearing protection, and ANSI-approved eye
protection (safety glasses, face shield, or goggles).
2. Make sure the Platform is fully lowered, the area around the Lift is clear of any obstructions,
and the Safety Lock Release Handle is in the lowered (Lock) position.
3. Open the Clamp wide enough to accommodate the front tire of the vehicle you are about to
move onto the Platform.
4. Push a vehicle onto the Platform. Never drive the vehicle onto the Platform.
5. Close the Clamp to secure the front wheel.
6. Use the Tie-Down Rings, the Tie-Down Poles, or any additional restraints until the vehicle is
secure on the Platform.
7. Before raising, make sure the vehicle is centered and balanced on the Platform.
⚠
WARNING
8. Use the Raising Pedal to manually raise the Platform or use the Raising Trigger to raise the
Platform using air.
You will hear the Safety Lock Plate clank as it passes each Safety Lock. It may clank less loudly or
not at all if you are using the Raising Pedal.
9. Go just past the desired height, then stop raising the Platform (stop pumping the Raising Pedal
or release the Raising Trigger).
RML-1500XL ATV / Motorcycle Lift
Do not raise a vehicle until you are sure all components are in place and working
normally. If you raise a vehicle without making a safety check first, you endanger
yourself and anyone else nearby and you risk damage to the vehicle and the Lift.
19
P/N 5900183 — Rev. E — Feb. 2020
Advertisement
Table of Contents
