Table of Contents
Advertisement
⚠
CAUTION
10. Use the Lowering Pedal to back the Platform down onto the most recently passed Safety Lock.
11. When the Platform stops moving, hold the Lowering Pedal down for several more seconds,
then check to make sure the Safety Lock Plate is engaged on the Safety Lock.
If the Safety Lock Plate is engaged on the same Safety Lock on both sides, the Platform is
engaged on its Safety Locks and is safe to use. You can now enter the work area.
If the Safety Lock Plate is not engaged on the Safety Lock or is engaged on different Safety
Locks, carefully lower the Platform back down to the ground and start again.
Do not enter the work area until you have confirmed the Lift is engaged on its Safety Lock.
Lowering a Vehicle
The Platform is lowered using the Air/Hydraulic Pump.
To lower a vehicle:
1. Make sure you are wearing OSHA-approved (publication 3151) Personal Protective Equipment:
leather gloves, steel-toed work boots, back belts, hearing protection, and ANSI-approved eye
protection (safety glasses, face shield, or goggles).
2. Check to make sure the vehicle on the Lift is secured and there are no obstructions under or
around the Platform.
3. Use the Raising Pedal or the Raising Trigger to raise the Safety Lock Plate off of the Safety Lock
it was engaged on. Do not go past the next Safety Lock.
In order for the Lift to lower, the Safety Lock Plate must not be engaged on a Safety Lock. To do
this, you first have to move the Safety Lock Plate up off the Safety Lock it was engaged on.
4. Move the Safety Lock Release Handle up and to the left, the Release position.
This raises the Safety Lock Plate, which allows the Lift to lower.
5. Hold down the Lowering Pedal on the Pump.
The Lift lowers.
6. When the Lift is fully lowered, continue to hold down the Lowering Pedal for several seconds,
then release it.
7. Walk the vehicle off the Platform.
RML-1500XL ATV / Motorcycle Lift
Do not raise the Platform past the top Safety Lock. In rare cases, the Safety Lock
Plate can go too far and get stuck past the top Safety Lock. If this happens,
manually lift the Safety Lock Plate to unstick it.
20
P/N 5900183 — Rev. E — Feb. 2020
Advertisement
Table of Contents
