Christie Boxer 4K30 Manual page 5

7. To free the lamp blower fan pack, remove the screw securing it.
8. Disconnect the J73 and J74 harnesses.
9. Free the harnesses from the clips.
10. Remove the lamp blower fan pack.
11. Disconnect the J75 harness and route free from the harness clips.
12. Disconnect the J72 NFCR harness (A side).
13. To release the top lamp duct module, remove the three screws.
14. To remove the outside lamp duct, loosen the three captive screws.
15. Disconnect the J72 inline connection located at the electronics bracket.
16. Slide the outside lamp duct assembly to the front of the projector and remove it.
17. Remove the top duct module.
18. Disconnect the cartridge inline connector from the lamp driver and P89 from the HKBA.
Installing the Boxer Harness Connect Backplates Instruction Sheet
020-102015-01 Rev. 1 (10-2015)
Installing the Boxer harness connector backplates
5