Christie Boxer 4K30 Manual page 4

1. Loosen the six captive screws securing the rear cover.
2. Remove the rear cover.
3. To install the rear cover, repeat these steps in reverse order.
Removing the integrator module
The integrator module is positioned between the two lamp cartridges and captures light from up to six
lamps and combines it into a uniform rectangular light source for the light engine.
Estimated replacement time: 16 minutes
1. Remove the top cover (on page 2).
2. Remove the optics-side cover (on page 3).
3. Remove the two screws securing the rear top support bracket.
4. Remove the rear cover (on page 3)
5. Remove the two lamp cartridges.
6. To release the vertical support bracket, remove the four screws.
Installing the Boxer Harness Connect Backplates Instruction Sheet
020-102015-01 Rev. 1 (10-2015)
Installing the Boxer harness connector backplates
4