Ricoh Pro C901s Operating Instructions Manual page 100

2. Basic Copying
Using the trimmer to cut the fore edge
Use this function to cut the fore edge of a document after it is saddle stitched.
• This function is available only when you select Center as the stapling position.
2 1. Select Center as the staple position.
2. Press [Output/ Customize Function/ Finisher].
3. Press [Fore Edge Cut].
4. Specify the cut length width with [ ] and [ ], and then press [OK].
To change the value you entered, press [Clear] and then enter a new value.
5. Press [OK].
6. Enter the number of copy sets using the number keys.
7. Place the originals, and then press the [Start] key.
• You can adjust the position of the fore edge cut from 2.0 to 20.0 mm (0.08 to 0.79 inches) in 0.1
mm (0.01 inch) increments.
• Empty the trimmer tray if prints are ejected with waste paper stuck to them. For details, see "Removing
Waste Paper", Troubleshooting.
98