Table of Contents
Advertisement
www.glp.de
Main screen
Press any button to activate the main screen.
The main screen contains the following information:
Top left: Firmware version – Tilt, Zoom and Pixel Mirror settings N (Normal) or I
•
(Inverted) – DMX Mode – Dimming curve
Top right: PWM Frequency
•
Center: Signal source (DMX, Art-Net...), DMX address and last DMX channel
•
occupied
Bottom left: the
•
menu
Bottom right: MENU indicates that the right-hand button opens the main menu
•
The example screen shown in Figure 2 gives the following information:
The fixture is running firmware v. 20
•
Tilt = N (Normal), Zoom = I (Inverted), Pixel Mirror = I (Inverted)
•
The fixture is in DMX Mode 1
•
The dimming curve is set to Soft
•
The PWM frequency is set to 3000
•
The fixture is set to receive data via DMX
•
The fixture's DMX address is set to 488 and the fixture uses DMX channels from 488
•
up to and including channel 512.
Information displayed when using Art-Net / sACN
See Figure 3. If the fixture is set up for control over an Art-Net or sACN network, the
signal source and currently set universe (Uni: starting from 0) appear above the DMX
address. The fixture's IP address is displayed below the DMX address. See 'Ethernet
config' on page 17 for details of how to configure the fixture's network address.
14
>>
symbol indicates that the left-hand button opens the Quick
Figure 3. Display, Art-Net / sACN networks
impression
FR10 Bar User Manual Rev. A
Advertisement
Table of Contents
