GLP impression FRIO BAR User Manual page 23

German Light Products®
Load Factory Backup
Important! Using this setting will return all the fixture's settings to factory defaults. This
includes all data network configuration such as DMX start address, IP configuration etc.
Note that you may lose communication with your controller!
LOAD FACTORY BACKUP does not affect device counters and calibration values.
Factory Menu
Important! Do not enter the Factory menu unless you are a trained service
professional. Read the fixture's service and calibration documentation, if
available, before entering this menu. In the Factory mode you can
change critical settings and cause damage to the fixture that is not
covered by the product warranty.
The Factory menu structure is normally hidden and is for use by the manufacturer or
professional service technicians only.
To enable the Factory menu the fixture must be powered on while holding the MENU /
ENTER button pressed for minimum 5 seconds. A warning message will appear in the
display. The Factory Menu will then be visible as the last item in the Main Menu.
The Factory menu stays enabled until the next power cycle. The control panel display is
set to constantly on and a Factory symbol is visible in the main screen while the Factory
menu is enabled.
RDM Address
Lets you edit the RDM Address of the fixture. This should always be the serial number of
the fixture.
Important! Make sure that the RDM address is correct, especially after changing the
mainboard. This is especially important for rental fixtures. If you have any questions,
please contact your GLP Support.
Feature Calibration
Lets you calibrate the fixture's effect and LEDs.
Important! Make sure that calibration is carried out correctly so that all fixtures in the
market perform identically. This is important for rental fixtures. If you have any questions,
please contact your GLP Support.
impression FR10 Bar User Manual Rev. A
23