GLP impression FRIO BAR User Manual page 22

www.glp.de
Service
The Service menu contains test sequences that are useful during service and
maintenance. It also contains an ADVANCED submenu which is for use by trained
technicians only. Read the information below carefully before entering this level.
Test Sequences
Runs different test sequences to check fixture functionality. Press the BACK button to
stop a test sequence.
Test All – Runs a test sequence of all features one by one.
•
Test Tilt – Runs a test sequence of Tilt movement only.
•
Test LED – Runs a test sequence of LED pixels only.
•
Test Zoom – Runs a test sequence of Zoom only.
•
Advanced Service
Entering this Submenu will allow you to do advanced fixture settings. You need to
confirm to enter the advanced Service level by holding enter for 3s.
Note: The Advanced Service Level is for trained technicians only. Read the information
below before entering this level.
Service Mode
Disables Tilt movement for convenience when servicing the head. Tilt is enabled again
at the next power cycle.
Note: You can also disable Tilt by pressing and holding the MENU / ENTER button for 3
seconds while powering on the fixture.
Offset
Lets you set customized offset values for each of the fixture's effects. This is a useful way
of temporarily adjusting multiple fixtures without changing fixture calibration.
Note: Offset Values are not calibration values. They are not deleted by a Load Setting
Defaults command but they are deleted by a Load Factory Backup command. If you
want to permanently adjust effects, use Feature Calibration in the Factory menu.
Reset Counters
Lets you reset the different fixture counters.
Note: Device Counters are not reset by a Load Factory Backup command.
Save Settings
Lets you save the current fixture settings to one of three custom fixture presets. After
saving a custom Fixture Setting Preset, you can reload it at any time using the Load
Fixture Setting Preset command (see FIXTURE SETTINGS  LOAD SETTINGS on page 21).
Note that the Default Preset is set at the factory and cannot be changed.
22 impression
FR10 Bar User Manual Rev. A