Table of Contents
Advertisement
7. Installation
Follow the installation guide to install the washing machine more conveniently.
Do not plug in the power cord when installing.
Before installation
After installation
Make sure to perform a test run to check for any water leakage or abnormal noise.
7-1. WHEN INSTALLING WITH THE BASIC INSTALLATION MATERIALS
1. Determine installation location
- determi n e the i n stal l a ti o n si t e, consi d eri n g the
structure of the area
※ I t i s easy to use when i n stal l e d i n a breast-hi g h l o cati o n
※ It is easier to use and install near the water pipe, drain
and the outlet.
4-1 Drill a hole into the tile
- Make a notch under the marked hol e s beforehand.
- Dri l l the hol e s, hol d i n g the tool perpendi c ul a r to the
wal l
※ Do not drill a hole on the edge of the wall tile.
※ Do not install the machine right below a faucet.
※ Use TE 2-S Soft Hammer dri l l from HI L TI or a Dri l l .
6. Fix the set anchors
- Fi x set anchors wi t h an anchor punch
※ If the anchor cap is above the wall surface after
fixation, repeat the step.
2. Inspect the wall
- Knock on the wal l to check i f the wal l i s concrete.
※ Install the machine on the even surface of the wall.
4-2. Drill a hole into the retaining wall
- Set the hammer dri l l or a dri l l perpendi c ul a r to the
surface of the wal l and dri l l a hol e i n to the
retai n i n g wal l .
※ Follow the instructions on the diameter and depth
specifications for the holes.
※ Remove dirt from the holes after drilling.
7. Connect inlet and drain hoses.
- I n sert the i n l e t hose unti l the el b ow makes a
snappi n g sound.
- Fi x the drai n hose to the synchronous motor and
connect the cl a mp i n si d e the synchronous motor.
※ Connect hoses properly to prevent any leakage.
※ Insert inlet and drain hoses into the back holes after
connection.
49
3. Attach the installation manual
- Attach i t usi n g a l e vel .
- After attachi n g the i n stal l gui d e, mark the hol e area.
※ Consider the actual size of the product and attach
the manual according location.
5. Insert set anchors (4 units)
-I n sert set anchors i n to the hol e s
-Set anchors are i n cl u ded i n the product
packagi n g
※ Insert set anchors into the end of each hole.
※ the set anchor bolt parts must be 75mm or longer
above the wall.
8. Plug in the power cord
- Connect the power as requested by the
customer (upward or downward)
- Connect the connector and fi x the groundi n g
cabl e .
※ Fi x the power cord ti g htl y wi t h cl a mp when connected upward.
※ Fix the grounding cables with flat screws.
※ Do not use multiple grounding cables in one spot.
Hide quick links:
Advertisement
Table of Contents
