Exchange Of Door Lock Switch; Check The Wire Connections In Door Lock Switch - Daewoo MINI Series Service Manual

Defects and
Details
Errors
Non- Power cutoff or
openable forced shutdown
Door during operation
The washer is "ON"
without any power
cutoffs.
Others

* Exchange of Door Lock Switch

[Disassembly]
1. Remove 4 body-fixing screws
2. Remove the detergent and softener containers
3. Remove 2 screws fixing the door hinge
4. Remove 6 cover screws fixing the cover tub
5. Remove 6 screws fixing the cover tub
6. Remove 2 screws fixing the door lock switch
7. Detach the door lock switch and F-PCB
connector
[Assembly]
Re-assemble the parts in the opposite sequence to
disassembly .
Inspection of Defects and
Causes
After the "power cutoff" or "forced shutdown" during operation,
"PCB MICOM" is not able to open the door. At least 5 minutes
must pass before the door becomes openable.
Water in tub Check whether the water level is above the
safety level.
High The door is automatically locked to prevent
temperature in damage from hot laundry after the spin
tub cycle is complete.
The door is automatically locked when the
connector, terminal, or solenoid wire gets
disconnected during operation. The
following instructions must apply to inspect
defects.

* Check the wire connections in Door Lock Switch

PIN
Arranage
ment
47
Resolution
Errors
2 3 4 5
(No.1 wire unavailable)
Error
Mode