When The Machine Cannot Be Installed With Basic Installation Materials - Daewoo MINI Series Service Manual

7-2. WHEN THE MACHINE CANNOT BE INSTALLED WITH BASIC INSTALLATION MATERIALS.

1. Determine installation location
- determi n e the i n stal l a ti o n si t e, consi d eri n g the
structure of the area
※ I t i s easy to use when i n stal l e d i n a breast-hi g h l o cati o n
※ It is easier to use and install near the water pipe, drain
and the outlet.
4-1 Drill a hole into the tile
- Make a notch under the marked hol e s beforehand.
- Dri l l the hol e s, hol d i n g the tool perpendi c ul a r to the
wal l
※ Do not drill a hole on the edge of the wall tile.
※ Do not install the machine right below a faucet.
※ Use TE 2-S Soft Hammer dri l l from HI L TI or a Dri l l .
6. Fi x the anchor bol t s on the pl a sti c anchor
- Fi x the anchor bol t i n the pl a sti c anchor usi n g a
dri l l or a spanner
※ Fix the anchor bolt by inserting it to the end of screw.
※ Connect and insert the bolt to the anchor using M6
fox.
※ If the bolt falls out with the drill due to a lack of depth,
drill and insert again.
2. Inspect the wall
- Knock on the wal l to check i f the wal l i s concrete.
※ Install the machine on an even surface of the wall.
4-2. Drill a hole into the retaining wall
- Set the hammer dri l l or a dri l l perpendi c ul a r to the
surface of the wal l and dri l l a hol e i n to the
retai n i n g wal l .
※ Follow the instructions on the diameter and depth
specifications for holes.
※ Remove dirt from the holes after drilling.
7. Connect inlet and drain hoses.
- I n sert the i n l e t hose unti l the el b ow makes a snappi n g
sound.
- Fi x the drai n hose to the synchronous motor and
connect the cl a mp i n si d e the synchronous motor.
※ Connect hoses properly to prevent any leakage.
※ Insert inlet and drain hoses into the back holes after
connection.
52
3. Attach the installation manual
- Attach i t usi n g a l e vel .
- After attachi n g the i n stal l gui d e, mark the hol e area.
※ Consider the actual size of the product and attach
the manual according location.
5. Insert the plastic set anchors (4 units)
- I n sert the pl a sti c anchor i n to the hol e .
※ Insert the plastic anchor perpendicularly on the wall.
8. Plug the power cord
- Connect the power as requested by the
customer (upward or downward)
- Connect the connector and fi x the groundi n g
cabl e .
※ Fix the power cord tight with clamp when connected
upward.
※ Fix the grounding cables with flat screws.
※ Do not use multiple grounding cables in one spot.