9. I n j e ct chemi c al anchor and i n sert cushi o n pads
- I n j e ct chemi c al anchors i n to the fi x ed set anchors
- I n sert cushi o n pads onto the fi x ed anchors
- Push the pads to the wal l .
※ When i n j e cti n g the chemi c al anchor, di s card the fi r st
10~15cm as the gl u e and hardener may not be mi x ed.
12. Fix the washing machine
- Connect pl a ne washer (1EA) and spri n g washer
(1EA), and connect a regul a r nut (1EA) and
connect a fi x i n g nut (1EA) l a st.
- Ti g hten the nuts wi t h ø14 spanner.
※ Excessive fastening of the nut may cause damage to
the washing machine or the wall tile.
※ Fixing nut must be fastened to the end.
ⓛ Cl o se the water suppl y val v e
② Di s assembl e the water suppl y val v e
③ I n stal l the branchi n g adapter (i n stal l
adapters accordi n gl y on col d and hot
water taps)
④ Branch off the i n l e t hose.
13-2 Install the inlet hose - a kitchen sink or a shower
① I n stal l the water tap connector on
the faucet (ski p i f i t i s a buri e d
faucet)
② I n stal l the branchi n g adapter.
③ Connect the i n l e t hose.
※ Check leakage after installation.
10. Install the washing machine.
- I n stal l the washi n g machi n e sti c k to the wal l
surface.
① Cl o se the water suppl y val v e ② Di s assembl e the water suppl y val v e
③ I n stal l the branchi n g adapter ④ Branch off the i n l e t hose.
※ Wrap the connection of the branching adapter and water supply valve with Teflon tape.
※ Check leakage after installation.
13-2 Install the inlet hose - a kitchen sink or a shower
- Organi z e and pl a ce hoses i n the hol e .
※ Caution: Be careful not to jam the hoses between
the wall and the washing machine.
13-1. Install the inlet hose - Regular faucet
Hot
Cold
water
water
- Run a test operati o n to check i f there i s any
mal f uncti o n / l e akage.
50
11. Organize hoses
For hot
water
For cold
water
14. Test operation