Advertisement
2.4 GHz 65 mW radios: 1 foot
900 MHz 150 mW radios: 6 feet
900 MHz 1 Watt radios: 15 feet
LED 1
Flashing green
Flashing red
Storage Mode and Sleep Mode
While in storage mode, the radio does not operate. All SureCross
the factory in storage mode to conserve the battery. To wake the device, press and hold button 1 for 5 seconds. To put
®
any FlexPower
or integrated battery SureCross radio into storage mode, press and hold button 1 for 5 seconds. The radio
is in storage mode when the LEDs stop blinking, but in some models, the LCD remains on for an additional minute after
the radio enters storage mode. After a device has entered storage mode, you must wait 1 minute before waking it.
During normal operation, the SureCross radio devices enter sleep mode after 15 minutes of operation. The radio
continues to function, but the LCD goes blank. To wake the device, press any button.
Modbus Register Table
I/O
Modbus Holding Register
Gateway
Any Node
1
1
1 + (Node# × 16)
2
2
2 + (Node# × 16)
3
3
3 + (Node# × 16)
4
4
4 + (Node# × 16)
7
7
7 + (Node# × 16)
8
8
8 + (Node# × 16)
15
15
15 + (Node# × 16) Control Message
16
16
16 + (Node# × 16) Reserved
Replacing the Battery (DX99...D Models)
To replace the lithium "D" cell battery in the metal housings, follow these steps.
1. Unscrew the lid of the metal enclosure.
2. Disconnect the radio by unplugging the ribbon cable from the radio board.
The radio board is mounted inside the metal lid.
3. Remove the discharged battery by pressing the battery towards the negative terminal to compress the spring. Pry up
on the battery's positive end to remove from the battery holder.
4. Replace with a new battery. Only use a 3.6 V lithium battery from Xeno, model number XL-205F.
5. Verify the battery's positive and negative terminals align to the positive and negative terminals of the battery holder
mounted within the case. Caution: There is a risk of explosion if the battery is replaced incorrectly.
6. Wait two minutes.
7. Plug the ribbon cable back into the radio board.
8. Screw on the lid and tighten.
9. After replacing the battery, allow up to 60 seconds for the device to power up.
6
LED 2
Flashing red
Flashing red, 1 per 3 sec
I/O Type
Discrete IN 1
Discrete IN 2
Analog IN 1 (mA or
V)
Analog IN 2 (mA or
V)
...
Reserved
Device Message
...
www.bannerengineering.com - Tel: +1-763-544-3164
SureCross DX99 FlexPower Node (Metal Housing)
Node Status
Radio Link Ok
Device Error
No Radio Link
®
radios powered from an integrated battery ship from
I/O Range
Holding Register
Representation
Min.
Max.
Min.
(Dec.)
0
1
0
0
1
0
0.0
20.0 or
0
10.0
0.0
20.0 or
0
10.0
Terminal Block
Labels
Max. (Dec.)
1
DI1
1
DI2
65535
A1+
65535
A2+
P/N 142497 Rev. L
Advertisement
