Banner DX99N9X1S2N0M2X0D2 Manual page 8

SureCross DX99 FlexPower Node (Metal Housing)
To unpack and wire the unit:
1. Open the end with the glass window and gently lift the
radio core and the space frame it sits on up. The core unit
connects to the space frame using two pins and the radio is
connected to the wiring board with a ribbon cable.
2. Disconnect the ribbon cable from the radio.
3. Insert the battery into the battery holder, verifying the
position and negative poles of the battery are positioned
according to the markings on the board.
4. Insert your sensor wires through a cable gland and one
of the two 1/2" NPT ports. Wire the sensor wires into the
terminal header according to the control drawings, p/n
141513.
Use a cable gland certified for your region and
environment. For a waterproof seal, refer to the
waterproofing instructions in Banner document 132607.
5. Install the terminal header onto the terminal pins.
8 www.bannerengineering.com - Tel: +1-763-544-3164 P/N 142497 Rev. L