Sauna Heater Stones; Accessories; Heating The Sauna - Helo ROCHER Instructions For Installation And Use Manual

2.4 Sauna heater stones

Quality stones meet the following requirements:
1. Sauna stones should withstand heat and heat variation caused by vaporisation of the water thrown on
the stones.
2. Stones should be rinsed before use in order to avoid odour and dust.
3. Sauna stones should have an uneven surface to supply a larger surface for the water to evaporate from.
4. Sauna stones should be large enough (intended for large sauna heaters, approx. 80 - 120mm), to allow
good ventilation between the stones. This extends the useful life of the heating elements.
5. Sauna stones should be piled sparsely in order to enhance ventilation between the stones. Do not bend
the heating elements together or against the frame.
6. Rearrange the stones regularly (at least once a year) and replace small and broken stones with new, larger
stones.
7. Stones should be piled so that they cover the heating elements. Do not, however, pile a large heap of
stones on the heating elements. For sufficient amount of stones refer to Table 2 on page 8. Any small
stones included in the stone delivery package should not be placed on the sauna heater, because they
might fall trought the heater's vertical beams.
The warranty does not cover defects resulting from poor ventilation caused by small and tightly packed
stones.
Structural clay tiles are not allowed. They may cause damage to the sauna heater Damages caused by using
structural clay tiles will not be covered by the warranty.
2.5 Accessories for Rocher sauna heater
Integration flange, soapstone
Integration flange, frosted glass
Led Drive optical fibre light

2.6 Heating the sauna

Before turning the sauna heater on, make sure the sauna room is suitable for taking a sauna bath. When
heated for the first time, the sauna heater may emit some odour. If you detect any odour while the sauna
heater warms up, disconnect the sauna heater briefly, and air the room. Then turn the sauna heater back
on.
The sauna heater is turned on from the control panel that has controls for the heating temperature and
time.
You should turn the sauna heater on roughly an hour before you plan to take a sauna bath, so that the
stones have time to heat up properly and the air warms up evenly in the sauna room.
Do not put any objects on the sauna heater. Do not dry clothes on the sauna heater or anywhere
in its vicinity.
EAN 6416976384299
EAN 6416976384374
EAN 6416976384893
5