If The Sauna Heater Will Not Heat Up; Instructions For The Installer; Preparing For Sauna Heater Installation; Installation - Helo ROCHER Instructions For Installation And Use Manual

2.7 If the sauna heater will not heat up

If the sauna heater will not heat up, please check the following:
- The power is on;
- The fuses for the sauna heater are intact;
- Any error messages on the control panel; In case of an error message, please refer to
the control panel operating instructions.

3. Instructions for the installer

THE PERSON INSTALLING THE SAUNA HEATER SHOULD LEAVE THESE INSTRUCTIONS
IN THE PREMISES FOR THE FUTURE USER.

3.1 Preparing for sauna heater installation

Check the following before installing the sauna heater:
1. The ratio of the heater's input (kW) and the sauna room's volume (m
recommendations are presented in Table 2 on page 8. The minimum and maximum volumes must not
be exceeded.
2. The sauna room ceiling must be min 1900 mm high.
3. Glass and stone surfaces will extend the pre-heating period. Each square meter of glass or stone ceiling
3
or wall adds 1.2m to the sauna room's volume in terms of needed heater input.
4. Check Table 1 on page 8 for a suitable fuse size (A) and the correct diameter of the power supply cable
(mm²) for the sauna heater in question.
5. Conform to the safety clearance around the sauna heater as specified in Table 2 on page 8. There
should be enough room around the sauna heater for maintenance purposes, a doorway etc.
6. If the the heater is integrated in the sauna benches, the bench model must allow lifting of the lower
bench and its frame without tools. The warranty will not cover dismantling and reassembly of sauna
benches.
3.2 Installing the sauna heater
Follow the safety clearance specifications in table 2 and images 3 and 4 on pages 8 and 9 when
installing the sauna heater.
The sauna heater is a free-standing model. The base must be solid, because the sauna heater weighs about
120 kg.
The sauna heater is levelled by the adjustable legs.
The sauna heater is fixed on the floor from its legs by the provided metal fasteners (2 pcs). This will keep
the safety clearances intact during use.
Walls or ceilings must not be clad light-weight cladding, such as incombustible protecting board, because
they may cause a fire hazard.
A single sauna heater is allowed per one sauna room.
3
). Volume/input
6