Sauna Heater Stones - Helo MAGMA Instructions For Installation And Use Manual

Instructions for use and installation

SAUNA HEATER STONES

Quality stones meet the following requirements:
- Sauna stones should withstand heat and heat variation caused by vaporisation of the water thrown
on the stones.
- Stones should be rinsed before use in order to avoid odour and dust.
- Sauna stones should have an uneven surface to supply a larger surface for the water to evaporate
from.
- Sauna stones should be large enough, measuring about 80–120 mm to allow good ventilation
between the stones. This extends the useful life of the heating elements. The maximum rocks
capacity is about 120kg
- Sauna stones should be piled sparsely in order to enhance ventilation between the stones. Do
not bend the heating elements together or against the frame.
- Rearrange the stones regularly (at least once a year) and replace small and broken stones
with new, larger stones.
- Stones are piled so that they cover the heating elements. Do not, however, pile a large heap of
stones on the heating elements. Any small stones in the package of stones must not be piled on
the sauna heater.
- The warranty does not cover defects resulting from poor ventilation caused by small and tightly
packed stones.
- Structural clay tiles are not allowed. They may cause damage to the sauna heater that will not
be covered by the warranty.
- Do not use soapstone as sauna rocks. Any damages resulting from this will not be covered by
the stove warranty.
- Do not use lava stone as sauna rocks. Any damages resulting from this will not be covered by
the stove warranty.
- DO NOT USE THE HEATER WITHOUT STONES.
MAGMA SKLA
and
3