Parametrizing - Festo CPX-FB13 Electronic Manual

2. Commissioning
2.2

Parametrizing

2.2.1 Parametrizing when switching on
1
Master loads
parameter set
into the node
2
Node distributes
parameter set to
the modules
Fig. 2/11: Sequence of start parametrizing
Festo P.BE−CPX−FB13−EN en 0503b
You can set the reaction of the CPX terminal individually by
parametrizing. A distinction is made between the following
parametrizings:
system parametrizing, e. g.: switching off fault messages,
etc.
parametrizing the diagnostic memory
module parametrizing (module and channel−specific),
e. g.: monitoring, settings in the event of faults, settings
for the debounce times of the inputs.
A detailed description of the individual parameters as well as
basic information on application can be found in the CPX sys
tem manual (P.BE−CPX−SYS−...).
Parameter lists for CPX I/O modules and CPX pneumatic in
terfaces can be found in the manual for the CPX I/O modules
(P.BE−CPX−EA−...).
PROFIBUS−DP
PLC/
Master
IPC
1
2
When the field bus system is switched on, the CPX terminal is
parametrized as Start parametrizing" by parameter set 1
saved in the PROFIBUS master. The field bus node then dis
tributes the parameters module−orientated to the CPX mod
ules 2.
2−33