What's On The Development Board - Digi ConnectCore Wi-9P 9215 Hardware Reference Manual

About the Development Board
What's on the
Development
Board?
www.digiembedded.com
C H A P T E R
T
he ConnectCore 9P 9215 Development Board supports the onnectCore 9P 9215
Family of modules. This chapter describes the components of the Development
Board and explains how to configure the board for your requirements.
The Development Board has two 4x20 pin connectors that are 1:1 copies of the
module pins.
RJ-45 Ethernet connector

Four RP-SMA antenna connectors.

– Connection to module via U.FL connectors
Four serial interface connectors:

– 1 x UART B MEI (RS232/RS4xx) with status LEDs on SUB-D 9-pin connector
(X6)
– 1 x UART D RS232 with status LEDs, on SUB-D 9-pin connector (X3)
– 1 x UART C with TTL levels shared with HDLC signals on 10-pin header (X5)
– 1 x UART A with TTL levels shared with SPI signals on 10-pin header (X4)
®
Socket for XBee

Peripheral application header

– Including access to 16-bit data/10-bit address bus signals
Headers with 1:1 copies of the module pins (X1/X2)

Two user pushbuttons, two user LEDs, one wake-up button

Eight-position configuration dip switches

2
module
62