Chapter 2: About The Development Board; What's On The Development Board - Digi ConnectCore Series Hardware Reference Manual

About the Development Board
C
T
he development board supports the ConnectCore for i.MX51 module. This chapter
describes the interfaces of the development board and explains how to configure the board
for your requirements.
The development board has two 180-pin connectors that mate with the module connectors.

What's on the Development Board?

Flexible 9-30VDC charger power supply with power-on switch

Screw-flange Battery header with enable jumper

3V coin cell battery

Connectors for Digi 802.3af PoE Application board (sold separately)

1 x UART RS232 with status LEDs and SUB-D 9-pin connector

1 x UART MEI (RS232/RS4xx) with status LEDs and SUB-D 9-pin connector

1 x UART with TTL levels

1 x USB OTG connector

4 x USB Host connectors

1 x SD/MMC card holder

1 x MicroSD card holder

SPI and I

Audio interface with Line-out, Line-In and Mic-In jacks

VGA interface

HDMI interface

2 x LCD connectors with Touch Screen interface

2 x Camera connectors

RJ-45 Ethernet connector

Connector for a Digi 100M_ETHADPT (sold separately)

© 2011 Digi International, Inc.
H A P T E R
2
C headers
2
55