Manual Tune; Prune Invalid; Drc (Dynamic Range Control) Value - TechniSat Digitradio 510 Instruction Manual

Manual Tune

1. Press MENU button, turn SELECT/TUNE knob to select Manual tune, and then press
SELECT/TUNE knob to confirm, the display will show the channel number and frequency.
2. Turn SELECT/TUNE knob to step among the channels and then press SELECT/TUNE knob
select the current channel.
#
Note: If there is a multiplex corresponding to this channel and frequency, then the display will show a
tuning meter with the signal strength and the multiplex name after a few seconds.
3. To exit manual tune, directly press SELECT/TUNE knob again.

Prune Invalid

You may remove all unavailable stations from the station list.
1. Press MENU button, turn SELECT/TUNE knob to select Prune invalid, and then press
SELECT/TUNE knob to confirm.
2. Turn SELECT/TUNE knob to select 'YES', and then press SELECT/TUNE knob to confirm.

DRC (Dynamic Range Control) value

You can set the compression level of stations to eliminate the differences in dynamic range or
sound level between radio stations.
#
Note: Set DRC to off indicates no compression; set DRC to low indicates little compression; set DRC
to high shows maximum compression.
1. Press MENU button, turn SELECT/TUNE knob to select DRC, and then press
SELECT/TUNE knob to confirm.
2. Turn SELECT/TUNE knob to select 'DRC high', 'DRC low' or 'DRC off', and then press
SELECT/TUNE knob to confirm.
22
→