Epson TM-300A Operator's Manual page 55

[Condition]
4. Roll paper supply device
Supply method:
Near-end detector:
Detection method:
l
Roll paper core inside diameter:
l
Near-end adjustment:
l
5. Roll paper take-up device
The TM-300A and TM-300PA are equipped with a take-up device. The paper
is automatically taken-up by the paper feed motor.
6. Auto-cutter
Both the TM-300A/B and TM-300PA/PB are equipped with the auto-cutter.
Full-cut/partial-cut can be executed by commands. (Refer to 6-3 Commands
ESCi, ESC m.)
7. Paper
Paper feed method:
Paper feed pitch:
Paper feed speed:
Paper size:
Roll paper
l
Paper width:
Character font:
l
Printing pattern:
l
Temperature:
l
Roll paper shaft-support loading
Micro switch
to 12.5 mm
Ø 10.5
Adjustable slider
(Refer to 3-3 Adjusting the Paper Near-End De-
tector)
Friction feed
Default 1/6 inch
Can be set in 1/144 inch units by software command.
Approx. 4.17 IPS (25 LPS) (continuous feeding)
(IPS: Inches Per Second)
(LPS: Lines Per Second)
76 mm ±0.5 mm
49
7 X 9 font
(with descenders)
ASCII 96-character rolling
pattern continuous printing
25°C