Epson TM-300A Operator's Manual page 48

ESC i
[Name] Execute full-cut
<1B>H<69>H
[Format]
[Description] Executes a full-cut of the paper.
[Note] Valid only when input at the beginning of a line.
l
ESC m
[Name] Execute partial-cut
<1B>H<6D>H
[Format]
[Description] Executes a partial-cut of the paper.
Valid only when input at the beginning of a line.
[Note]
l
ESC p m n1 n2
[Name] Generate drawer kick-out drive pulse
[Format] <1B>H<70>H<m><n1><n2>
0
[Range]
0< n1
[Description] The pulse set by
The value of m is used as follows:
l
m
0
1
[Notes] The circuit on the user side should be designed so that the
l
drawer drive duty will be as shown below.
ON time + OFF time
ON time is
It is recommended that
The resistance of the drawer kick-out solenoid shall be 24
l
or more. Otherwise, the overcurrent will flow.
Be sure to use the printer power supply (pin
l
power source.
Neither m,
[Default]
[Reference] APPENDIX B Connectors and APPENDIX E Notes on Using
the Drawer Kick-out Connector.
m 1
n2 255
n1 n2
and
Connector pin
Drawer kick-out connector pin 2
Drawer kick-out connector pin 5
ON time
n1 X 2
ms, and OFF time is
n1,
nor n2 is defined.
4 2
is output to the connector pin m.
0 . 2
n2 X 2
n2
be four times as much as
ms.
n 1.
4)
for the drawer