Epson TM-290-II Operator's Manual page 35

inches in the reverse direction.
• Sets the print starting position to beginning of the line.
• The predetermined line spacing remains unchanged.
Notes
• Valid only in Standard Mode.
Default
Not defined.
ESC L
Name
Select Page Mode
Format
< 1 B >
Description
Switches from Standard Mode to Page Mode.
• In Page Mode, the printer prints all the received data (stored
in the specified printable area) at one time upon receiving an
FF
LF
• The printer returns to Standard Mode after printing the data
in the specified printable area (when
Notes
• Valid only when input at the beginning of a line.
• In Page Mode, only normal dots are used (half dots are
not used). Therefore, pay attention to settings using half-
dot units in Standard Mode.
<Settings for
These commands have two. kinds of setting values, for
Standard and for Page Modes.
< Character font >
Only the fonts consisting of just normal dots are valid.
< Invalid commands in Page Mode>
The following commands are ignored in Page Mode:
Commands which pertain to reverse paper feeding such as
ESC e
Upside-down character printing in ESC {.
The selection of a 7X7 font and the specification of
underlines in ESC !.
The setting of a double-density bit image in
ESC q.
< 4 C >
H H
command. Therefore, normal print commands such as
are stored in memory but do not cause actual printing.
ESC SP, ESC 2, ESC 3
ESC K.
and
- 3 0 -
FF
is received).
and others>
ESC * .